What is the best material for fascia boards?
Typically for fascia boards, cedar and redwood are popular choices given their resistance to rot from excessive moisture. However, if you prime and paint the fascia, then fir, spruce, and pine can also make beautiful choices from a design standpoint.
What sizes are fascia boards?
Fascias are typically made from 1-inch material, with the width being enough to cover the rafter width. Typically rafters will range from 2×6 to 2×8, although some are larger depending on the roof construction. Therefore, the more common fascia board sizes are 1×6 or 1×8.
What can I use instead of fascia board?
Vinyl. Vinyl siding is a common alternative to fascia board. This type of rafter facing does not rot or wear as quickly as fascia board under the same weather conditions.
What width does fascia board come?
Replacement fascias do vary in thickness by manufacturer, but the rule of thumb is that to qualify structurally as a replacement board they should be somewhere between 16mm and 25mm thick – our most common range is the 18mm Replacement Fascia.
How much should it cost to replace fascia boards?
Replacing your soffit generally costs about $20 to $30 a linear foot installed, while replacing your fascia costs about $15 to $25 a linear foot installed. Prices for the project depend on a number of factors, including the materials used and the size of your house.
Can you use Hardie board for fascia?
Fred S. Prefinished fascia is not really a priority if you are using Hardie. It would only need to be prefinished if it was metal. Both the Hardie and Miratec will end up with extensive face nailing.
What is behind a fascia board?
Soffit. The soffit board is tucked away under the fascia board. It is usually the board that you see most of from street level. The soffit can be ventilated to allow the flow of air into the roof area.
Can Plywood be used for fascia?
Even though plywood siding isn’t a good fascia material, it works well for soffits, which are out of the rain and have to be painted and cut to install light fixtures and vents.
How long is a piece of fascia?
Report the length of fascia in the widths you need. Typical widths of fascia are 6 and 8 inches. As a rule of thumb, always order 10 percent more material than calculated to ensure you have enough material.
Can I use 2×8 for fascia board?
Wood Is a Common Fascia Material Cedar is a popular fascia wood and redwood is another. The width depends on the width of the rafters, but since builders generally use two-by-six or two-by-eight lumber for roof construction, the most common dimensions for fascia boards are one-by-six and one-by-eight.
